T.A. Flash Clean

  • Restores the nutrient balance
  • Eliminates nutrient deficiencies caused by overfertilization
  • Nourishes microorganisms and regenerates soil and coco fibers
  • Suitable for hydro, coco and soil

More details

6,95 €

Grundpreis: 13,90 €/Liter

- +

 
More info

FlashClean's special mineral salt-dissolving formula breaks the nutrient bonds between minerals and substrate, which are then simply flushed out. And plants can make the most of the remaining nutrients in the crucial week before harvest.

Unlike other rinses or other final treatments on the market, FlashClean is not an acid or enzyme cleaner, does not deposit magnesium or other mineral additives in the system, and is therefore enormously versatile in use: with FlashClean, you can create a clean, regenerated starting base for your system and your plants at any point in the development process.

No matter where or how you grow plants - indoors or outdoors, in soil or without, in hydroponics, pots or beds - FlashClean is absolutely straightforward: just mix it in pH-regulated water and apply.

Application:

In hydroponic systems:

  • For restarting and refreshing before fertilizer change: add 1.5 to 3 ml FlashClean per liter to the existing nutrient solution and let it circulate for 24 hours before preparing a new nutrient solution. Choose the lower dosage for young or sensitive plants and the higher dosage for established plants or those about to be harvested.
  • After a burnout or overfertilization: Drain old nutrient solution, add 1.5 to 3 ml of FlashClean per liter of pH-corrected water (you don't need to fill the tank completely, just enough to run the system). run for 24 hours, drain the tank and add new, fresh nutrient solution. Choose the lower dosage for young or sensitive plants and the higher dosage for established plants.
  • As a final rinse (after FinalPart): drain old nutrient solution, add 1.5 to 3 ml of FlashClean per liter of pH corrected water (you don't need to fill the tank completely, just enough to run the system). Run the last two days before harvest to increase the sugar content of your crop, instead of losing flavor and active ingredient by flushing the water for days.

In substrate and soilless mixes:

  • For restarting and refreshing before fertilizer changes, or after overfertilizing: Every 2 weeks (or as needed for nutrient blockage), fill a watering can with fresh pH-corrected water and add 1.5 to 3 ml of FlashClean per liter. Soak the pot until the liquid runs out the bottom of the pot. At the next watering you can resume the usual nutrient supply. Choose the lower dosage for young or sensitive plants and the higher dosage for established plants.
  • As a final rinse/after FinalPart: use 3 ml of FlashClean per liter of water instead of fertilizer during the last two days before harvest to increase the sugar content of your crop, instead of flavor and active ingredient losses due to a days-long water rinse.

Tip:

FlashClean can be used at any stage of growth or flowering, but no more than once every two weeks.

 
Data sheet
Shipping Paket

Write a review

Frage (0)

Bisher hat noch niemand eine Frage zu diesem Artikel gestellt. Stelle jetzt Deine Frage! Wir antworten normalerweise innerhalb von einem Tag.


Deine Frage wurde erfolgreich versendet. Vielen Dank! Wir melden uns normalerweise nach einem Werktag bei Dir.
Frage stellen
Formular schließen

Customers who bought this product also bought:

13 other products in the same category: